Page 1 of 1
G0 Z0 command is correct, but when print starts nozzle is too high?
Posted: Thu Jun 22, 2017 10:50 am
by craftymethod
Hey guys Rostock V2 here.
it seems my nozzle height is good but when i try and do my first layer, its several mm too high. HR is giving a nice horizontal movement, just generally too high.
Software is simplyfy 3D.
Re: G0 Z0 command is correct, but when print starts nozzle is too high?
Posted: Thu Jun 22, 2017 3:39 pm
by craftymethod
To clarify, nozzle is paper width when manually jogging to g0z0. When print initiated, its more than a paper height, but is consistent at that height a too high height.
Whats different when printing than manually moving to Z0?
Re: G0 Z0 command is correct, but when print starts nozzle is too high?
Posted: Thu Jun 22, 2017 4:01 pm
by knabo
In the advanced options of S3D are options to set slicer offsets for each axis. maybe you have a number in the Z box.
Re: G0 Z0 command is correct, but when print starts nozzle is too high?
Posted: Fri Jun 23, 2017 7:12 am
by Mac The Knife
Another thing to check in S3d,,,, Go to the advanced setings and make sure that your "Start Printing at height" box isn't checked, or not set for zero.