Page 1 of 1
Chuckle - now I think about holddowns.
Posted: Sun May 28, 2017 1:11 am
by Dionysus480
OK - so I got the new mhackney snowflake replacement for FSRs, and I have it installed on my v2. I'm looking for a way to secure my heat spreader and glass build plate.
Any have a favorite glass build plate clamp they care to share?
Re: Chuckle - now I think about holddowns.
Posted: Sun May 28, 2017 9:57 am
by geneb
Binder clips.
g.
Re: Chuckle - now I think about holddowns.
Posted: Sun May 28, 2017 8:38 pm
by Dionysus480
Thanks! But of course the problem is that there is no clearance for binder clips. I'll need to design something cool like the v3 has. Of course I need to hold the plate on while I print. Maybe some tape as a temporary holder. Bet my trigger point changes for the fsr between tape and an actual firm hold down clamp.
Re: Chuckle - now I think about holddowns.
Posted: Mon May 29, 2017 9:47 am
by geneb
Ah, I wasn't aware of that. Even the small ones won't fit?
g.
Re: Chuckle - now I think about holddowns.
Posted: Mon May 29, 2017 4:42 pm
by dc42
Swiss Clips take up much less room than binder clips.