new probing board problem
Posted: Wed Oct 12, 2016 10:44 am
Hi,
So I finished upgrading my v2 to the new probing board.
I installed the board with the e3d v6 hot end.
after updating the firmware when I turn the printer on is stuck on the splash screen.
I I disconnect the I2C connector it will start up hust fine and i can home and heat the bed and all just like before.
i tried to switch the I2C wires - still wont work.
can someone please help.
thanks
So I finished upgrading my v2 to the new probing board.
I installed the board with the e3d v6 hot end.
after updating the firmware when I turn the printer on is stuck on the splash screen.
I I disconnect the I2C connector it will start up hust fine and i can home and heat the bed and all just like before.
i tried to switch the I2C wires - still wont work.
can someone please help.
thanks