Welcome to the SeeMeCNC Community

Posted: **Fri Jan 18, 2013 7:12 pm**

Repetier is too involved for me, I have slic3r but want to try something new. What's out there?

Posted: **Fri Jan 18, 2013 9:31 pm**

tom10122 wrote:Repetier is too involved for me, I have slic3r but want to try something new. What's out there?

The only slicers I'd use at this point are KISSlicer or Cura.

Posted: **Fri Jan 18, 2013 10:52 pm**

I use Cura for just about everthing now... Kisslicer is also very good, I gave up on Slicer long ago...

Posted: **Fri Jan 18, 2013 11:06 pm**

thanks guys

Posted: **Sat Jan 19, 2013 10:17 am**

I'm getting hung up with cura, it generates m-codes that don't work with EMC2 any ideas?

Best slicing software?