Top Layer
Posted: Sat Jul 30, 2016 6:02 pm
Just ran a part (lounge chair coaster) I created in FreeCad and G-code created with Slic3r. The surface with the "C" is flat, yet it printed very rough with oddball "tracks". Would I be better off trying Cura, or different settings? .2 layers, 3 solid Top/bottom layers, 25% infill honeycomb concentric. Suggestions?
PS: Don't order Hatchbox dark brown if you don't want dark purple! Exchanging this roll for black.
PS: Don't order Hatchbox dark brown if you don't want dark purple! Exchanging this roll for black.