Re: Excessive stringing
Posted: Thu Nov 19, 2015 8:56 pm
Interesting! I use 200 mm/s for non-print moves - so pretty fast, but not as fast as you're going.
What ended up solving my stringing problems was turning the layer fan off - I had it at a minimum speed of 80% for some reason, but reducing to to 0% cuts the stringing back to nearly nothing. I now keep it at a minimum of 25% and that produces very little stringing. I set it to 100% speed during bridging. So that was my big solution - thanks for reminding me to share that back here.
What ended up solving my stringing problems was turning the layer fan off - I had it at a minimum speed of 80% for some reason, but reducing to to 0% cuts the stringing back to nearly nothing. I now keep it at a minimum of 25% and that produces very little stringing. I set it to 100% speed during bridging. So that was my big solution - thanks for reminding me to share that back here.