Welcome to the SeeMeCNC Community

Posted: **Sun Dec 28, 2014 1:48 pm**

Thanks for the info.

The fact of not trying to plug onto the Rambo probably makes things easier, and eventually better routed than my solution.

I'll try to give it a closer look someday.

Posted: **Mon Jan 05, 2015 2:50 am**

Highcooley wrote:However, I have to warn you as until today, Repetier 0.91 has still two hiccups if set to 4 extruders. The problems are documented here and the issues have been reported to Marcus from Repetier:
http://forum.e3d-online.com/viewtopic.p ... 1899#p1899

Update: 05.01.2015
The issue has been resolved in the current development branch 0.92 by Marcus. Once again, he did a splendid job correcting the problem super fast. Thank you Marcus!

Welcome to the SeeMeCNC Community

Upgrading the Rambo (mod)

Re: Upgrading the Rambo (mod)

Re: Upgrading the Rambo (mod)