Closed loop stepper motors on duet2

Post Reply
carl22
Noob
Posts: 1
Joined: Tue Jun 11, 2024 3:29 am

Closed loop stepper motors on duet2

Post by carl22 »

Hello, I occasionally read on the forum. Now I have a question and Ryan from Ooznest told me to place it here.
Because he had no experience with closed loop stepper motor.

I try to connect closed loop stepper motors to a duet2 with an expansion breakout board. Before I had normal stepper motors with external drivers on the duet.
When I use the jog commands (G0) with the buttons it works. When I use a other command,like homing (G1), it goes wrong. Stuttering movements and the distance is no longer correct. The distance is ok when i use the buttons.

If i set the closed loop running off with a switch, same result.
The strange thing is that the driver does not give an alarm for the missed steps. So the driver does not see the missed steps.
When I block the motor, the driver go in alarm because of missed steps.

Does anybody have experience with this? Or an idea how to solve this?
geneb
ULTIMATE 3D JEDI
Posts: 5351
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Closed loop stepper motors on duet2

Post by geneb »

You might have better luck on the Duet3D forum, here: https://forum.duet3d.com/

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “Duet”