Welcome to the SeeMeCNC Community

I'm getting horizontal banding, and dotted lines, some layers appear to be smooth while others not. Something noting as well is the horizontal banding seems consistent across each individual layer that has the issue. The things I've taken into consideration is: 20201220_235226.jpg 20201220_205603 ...

Try Mattercontrol, other slicing softwares if that does the same thing you can conclude it's the communication from Rambo-PC for sure. If you have a spare USB to Rambo cable I suggest replacing it otherwise that might be the issue.

Yea, I just added a heatsink, I'm thinking because it prints small prints well until it heats up that the firmware side is "good". I just ordered a stepper motor to replace it, the heatsink only extended the printing duration ever so slightly till it gets hot. I got a fan that i'll be adding on the ...

Thanks for the input, I just ordered a stepper motor heatsink with a fan, trying that out. Something I noticed the other day, I took off the extruder component off the motor, so no load and commanded the motor to move 10mm through matter control. I noticed that after it extrudes, current is still ...

Hello fellow 3D printer peeps, I'm facing an issue where my stepper motor gets pretty hot, i'd say 80C and above. I've been running PLA on this printer and noticed that it just begins to melt 50minutes+ in which the stepper motor starts to melt the PLA and clogging occurs. So far the hot end is ...