Welcome to the SeeMeCNC Community

Hmmm - I'll have to take a look at that from the image on the instructions page, it looked like the chamfer was on the inside and it states that it goes into the single end of the Y adapter. I made the assumption this was to help guide the filaments as they would be changed often - and possibly need ...

Hi All- So I've been doing some work to the RoV2 and converting it to a dual extruder with HE280. (I've had some issues with the original build and placed the notes here: http://forum.seemecnc.com/viewtopic.php?f=112&t=12022&p=105559&hilit=dual#p105559 I was hoping to start a thread on the general ...

I did have some issues I will document here - hopefully it helps someone. 1. I needed to make new top side panels for the NEMA motors to fit in since the V2 vs V3 with dual extruders has shorter panels - in the V3 this wouldn't be necessary as the mount for the ezstruder is already on the side - and ...

Hi All, first time poster - long time reader...This is a longer post so I figured breaking it up a bit would make it easier. This first section is about the hardware install on a V2 with HE280 and dual extrusion. So I just completed upgrading my V2 to the new HE280 and Dual extruder. I am having a ...