Welcome to the SeeMeCNC Community

Thanks for posting the baud rate! Older version of octoprint would detect the baud rate on its own. Explicitly setting the 250000 value fixed my connections issue.

Thanks again.

This is not exactly what you requested, but on page 4 of Mhackney's real v3 build thread he tackles this annoyance in a clever way.

I've linked to the page below.

http://forum.seemecnc.com/viewtopic.php ... 6&start=75

-W

That is a good doc on printed solid. Any improvements on your end?

Have you seen this article regarding the proper seating of the boden tube?

https://seemecnc.zendesk.com/hc/en-us/a ... lament-JAM

As a follow up, if I set the hot end to 150 the bed will begin heating. If I catch the bed at around 45 - 50 C and start printing, the runaway condition is less likely to occur. Is there a difference in heating commands when I set the temp via LCD or if I set the temp in my Gcode?

Thanks.

Hello, been wrestling with my heated bed on my Rostock Max V3 for the past few weeks. For some background, my heated bed appears to only heat while the hot end is active. Is this by design? Going through the LCD menu I choose >> Adjust Temps >> Bed Temp >> Set to anything, let's choose 50C. The bed ...

I was wondering if these have changed now that you've migrated to the V3. I am happily using matter control with my v3 at the moment, but am considering running KISS in parallel to have two slicers for comparison.

Thanks

Thanks for the great explanation. I have been messing with retract speed and settings in matter control for a week or so. Been happily printing on a Rostock MAXv3 however I still have a minimal amount of stringing even with 6 mm retract settings. I have followed your settings pages pretty thoroughly ...