about the Autotune, is there a way to autotune both bed and hot end at the same time... I think it would be more accurate than autotune the hotend while the bed is off.
Jeff Jr
Search found 7 matches
- Wed Jan 25, 2017 12:04 pm
- Forum: Troubleshooting
- Topic: Solved - New Pre-Assembled Hot End Issues
- Replies: 17
- Views: 11422
- Thu Jan 12, 2017 8:36 pm
- Forum: Rostock MAX v2
- Topic: HE280 on Max V2 - Probing stops halfway through, board unresposive
- Replies: 14
- Views: 10637
Re: HE280 on Max V2 - Probing stops halfway through, board unresposive
You are the man Thanks!!!
- Wed Jan 11, 2017 8:16 pm
- Forum: Rostock MAX v2
- Topic: HE280 on Max V2 - Probing stops halfway through, board unresposive
- Replies: 14
- Views: 10637
Re: HE280 on Max V2 - Probing stops halfway through, board unresposive
I have the same issue with 8 pin connector easily gets loose on the HE280 hotend. So I temporarily fixed it with tape but I am looking for something is permanently fixed. I did find the post that is related to this issue and someone did design a clip to secure the connector in place but I can't seem ...
- Wed Jan 11, 2017 7:53 pm
- Forum: Troubleshooting
- Topic: Solved - New Pre-Assembled Hot End Issues
- Replies: 17
- Views: 11422
Re: New Pre-Assembled Hot End Issues
Awesome!
Jeff Jr.
Jeff Jr.
- Wed Jan 11, 2017 7:23 pm
- Forum: Troubleshooting
- Topic: Solved - New Pre-Assembled Hot End Issues
- Replies: 17
- Views: 11422
Re: New Pre-Assembled Hot End Issues
At the power supply box; there is a potentiometer at the left of the 12VDC output. You can turn it up between 12.5 and 13V DC. Yes you need a voltmeter.
Regards,
Jeff Jr.
Regards,
Jeff Jr.
- Wed Jan 11, 2017 7:08 pm
- Forum: Troubleshooting
- Topic: Solved - New Pre-Assembled Hot End Issues
- Replies: 17
- Views: 11422
Re: New Pre-Assembled Hot End Issues
Also test the voltage output of the power supply. You might need to turn up the voltage output between 12.5V and 13V DC.
Jeff Jr.
Jeff Jr.
- Wed Jan 11, 2017 7:04 pm
- Forum: Troubleshooting
- Topic: Solved - New Pre-Assembled Hot End Issues
- Replies: 17
- Views: 11422
Re: New Pre-Assembled Hot End Issues
Chris,
I had the same issue with the temperature reaching to the target. The red switch in the side of the power supply box; make sure it's 115, not 230. Obviously i had 230 the whole time with V2 stock hotend.
I had the same issue with the temperature reaching to the target. The red switch in the side of the power supply box; make sure it's 115, not 230. Obviously i had 230 the whole time with V2 stock hotend.