Welcome to the SeeMeCNC Community

Okay, thanks for the technical support. To solve I went in to Repetier Host, selected the "Config" pulldown menu, clicked on "printer settings" (cntrl + p) and clicked on the "printer" tab (second tab over) and then unchecked the box next to "Go to Park Setting After Job/Kill" then clicked Apply and ...

When my Rostock MAX finishes a print, it returns to the top and then goes crazy swinging to one side. My concern is when it swings to the side, I can hear the drive belts skipping on the toothed pulley. This can't be good. I tried to manually enter an "all stop" code at the end of the gcode, but it ...

I'm using the Marlin firmware downloaded as described in the Rostock assembly guide/manual. Is it just easier to revers the wires on the stepper? Otherwise, what lines do I need to change in the firmware? Thanks!

When in the repetier software, using the manual controls, I have the extrude value set to 10 and the retract set to 5. When I press the manual extrude button ( the top one with the down arrow) it pulls back 5mm and when I press the manual retract button (the bottom arrow that points up) it extrudes ...

Hello everyone,
My current setup problem with my rostock is my extruder, it runs backwards. Whats the easiest way to fix this? I have looked around in the firmware configuration.h file but am unsure what to change. Any help appreciated...
grayd

Hello all. During calibration of the hot end I had to upload the new hot end cycle settings to the firmware on the Rambo card. After doing this, my Z location became invalid. After moving the hot end (via manual entry of Gcode in the Repetier Software) down to double check the deck calibration I ...

Ahh, baud rate was the problem. Apparently the default was too low. Thank you, on to calibration!
grayd

I have the rostock plugged into the USB connection, port is live, Repetier software recognizes that the machine is powered up and connected but when I try to run the setup commands in manual control nothing happens. When I hit the connect button in the software it updates from disconnected to ...