Welcome to the SeeMeCNC Community

First of all, great job for version 3 of this great tool. During this writing I am still trying to complete calibration process after heat-bed is changed. With 3.0.0A calibration process (Basic calibration) took very long as it pause for 2 seconds after every move. Is there any parameter that can be ...

Have you experimenting with different types of calibration ? I have tried just "Calibrate" and "A.I. Calibrate" but without luck. Only "H.A.I. Calibrate" did give me positive results. Event with HAI, 2/3 attempts finish by getting some crazy values and smashing sensor to bed, or even worse total ...

Have you first clear all EEPROM values to default ?
If you are not sure, re-flash Repetier firmware with different EEPROM slot value to clear EEPROM.

lordgort wrote:so i should try z-probe start heigh : 310mm?

No !
Go in Repetier-Host and Firmware Settings (if your firmware is EEPROM based) and change Z probe max bed sistance to at least 310mm.
Then close Repetier-Host and try with OpenDACT.

how did you exactly do to solve this problem? sorry, english is not my mother language and the names for the parameter in the programm are not well enough described for me. z-probe-bed distance? If your Z probe max bed distance is too low, for ex. 10mm, maximum distance firmware measure is 10mm ...

duvdev wrote:Hi

I am trying to use the z probe.

after the first 6 points when in going down fo the second round it always hits the glass.
can some please tell me y?

thanks

I had similar problem when Max. z-probe - bed dist was set too low. It should be maximum distance (more then Z max).

Great job guys, Until this program, I have used to manually calibrate printer with just XYZ offsets which took me 3-4 hours for each calibration. Now, job is done automatically in less then hour. Here is mine full calibration video: https://www.youtube.com/watch?v=cQ1uTnZpUzM I have designed and ...