Welcome to the SeeMeCNC Community

Hey guys... just wanted to let you all know that I recently had CS Hyde cut some custom 310mm PEI sheets (10mil thick) with 3m adhesive backing pre-applied for my v2. They added it to their site as a normal product so they'll be easier to order in the future. Hope someone finds them useful! http ...

both motors are the same in terms of resolution. best mods i've done so far are anti-lash straps (printed my own out of ninjaflex), e3d v6 and smoothieboard/fsr/autocalibration setup.

i recently upgraded to smoothieboard and implemented 626pilots auto-calibration using FSRs. i highly recommend the FSRs in place of the hall-o, as it removes the need for accurate probe offsets and seems to be a bit more repeatable in my experience. they're very easy to set up rather cheap as well ...

I just finished setting this up on my smoothieboard using the same FSRs... the results are spectacular. every delta machine should have this capability. thanks!

No worries at all... not sure if i didn't receive them or just didn't see them in the package and accidentally threw them away :). In any case, all it took was a trip to Lowe's and everything is squared away. Got everything mounted up now and after a bit of tribulation getting it all calibrated it's ...

I did get the E3D version. It didn't come with any hardware, just 2 laser cut wood pieces. I also ordered the 40mm carbon standoffs, so they were included as well. I think I may have figured it out, though. The groove mount was loose which confused me (grooves is much later than the 'slot' it slides ...

Hello all... first post so thanks for the awesome forum :). I've recently picked up and built a Rostock Max V2... went together smoothly but now I'm down to installing the hot end and have an issue. I intend to use an E3D V6 that i have laying around and have bought the tricklaser groove mount to ...