Search found 5 matches
- Mon Mar 23, 2015 12:09 am
- Forum: Troubleshooting
- Topic: PID Autotune Failed! Timeout
- Replies: 9
- Views: 7719
Re: PID Autotune Failed! Timeout
Well that did the trick. I was looking in all of the wrong directions for a solution. Thank you so much.
- Sun Mar 22, 2015 10:54 pm
- Forum: Troubleshooting
- Topic: PID Autotune Failed! Timeout
- Replies: 9
- Views: 7719
Re: PID Autotune Failed! Timeout
NOZ reads 23.6C at room temperature.
Went ahead and took a screen shot of the PID portion of EEPROM settings
Went ahead and took a screen shot of the PID portion of EEPROM settings
- Sun Mar 22, 2015 10:11 pm
- Forum: Troubleshooting
- Topic: PID Autotune Failed! Timeout
- Replies: 9
- Views: 7719
PID Autotune Failed! Timeout
After searching through the bowels of the internet, I can't seem to find any relevant information regarding the PID autotune timing out. I installed my E3D V6 on my rostock this afternoon and it can't seem to go above 100~ C. The only modification to it is that I also installed a screw-on thermistor ...
- Sun Mar 22, 2015 5:31 pm
- Forum: Troubleshooting
- Topic: Vertical Separation in Print
- Replies: 3
- Views: 2828
Re: Vertical Separation in Print
Thanks for the replies. I'll try it out again today.
- Sat Mar 21, 2015 4:49 pm
- Forum: Troubleshooting
- Topic: Vertical Separation in Print
- Replies: 3
- Views: 2828
Vertical Separation in Print
Hello all, I've been using my rostock max v2 for about 3 weeks now off and on, and despite resolving most issues using the forums and other resources, I have one issue that seems to persist. With most prints, it looks like the wall is separating in a nearly straight line vertically. I'm not quite ...