Welcome to the SeeMeCNC Community

hey thanks a lot, Ironcoot.
glad someone on this board is willing to lend a hand.

teoman wrote:Those of us who followed the manual got the values from the pid autotune.

Yeah and it didnt work.
The defaults now if you don't mind.

I tried doing the PID calibration for my heated bed and replaced the values without at least writing them down. now it can no long reach temps above 90c which is keeping me from printing ABS. Could someone please post the default PID settings so I can get this corrected?
PLEASE AND THANKS.

I was also stuck on this for while. The eazy button gave me a very hard time.

I also just tuned my bed for 'more accurate heating' I dont remember ever having issues ever heating it to 100c but now it crawls to a stop at 93c. when i did the PID auto tune the values were way off but I foolishly didnt write them down. now my bed takes forever to heat and its very annoying ...

I got it. Slic3r first layer setting.

Hey HI UPDATE The wiring was a little off i fixed it everything works fine now. Ran the PiD weirdly though i got 2 PID values, not sure whats going on here. Also after the PID routine the arm giggled a little, it was a bit odd, thought i should report these minor hicups anyway. By the way these are ...

hey thanks RocketMagnet I don't think the change in the firmware had any effect but upping the temp definitely did help the prints. Also i noticed that when I start prints the hotend will drop the temp to 200 despite any settings I have made and I manually have to crank it back up. I have the ...

Hey guys im having a weird issue that im thinking is in the firmware or in repetier somewhere but i cannot find it. Every time I start a print the temp on my hotend will drop to 200. In config > printer settings i have the defualt temp set as 225 and the max temp set as 245. every time i print the ...

I am also having this issue. all steppers running hot and giving a high pitched annoying sound. the extruder is stripping my filament now as well which is really unfortunate because im trying to calibrate it so that finally use this blasted printer. Im thinking this could be the cause of my under ...

Hasn't been the simple kit I expected.