Welcome to the SeeMeCNC Community

On the minus side, the stupid part ripped off a chunk of the borosilicate glass plate :o Talk about a bummer! I've only had the thing up and running for less than a week, and now I've already got to replace the plate? I'm with you, the exact same thing just happened to me this evening. I didn't ...

I'm starting to suspect this most recent problem was a pinched wire. I hadn't pulled the wire all the way back through when I reassembled it, and after doing so it appears to be functioning. That being said, would you recommend upgrading the power supply to better handle the Onyx bed? I'm currently ...

That is starting to make sense, unfortunately the problem keeps getting worse. Now I can't even select the "Change Temp" option without it turning itself off... Correction: I just took the glass off and left the Onyx bed sitting loose, it seems to be letting me get through the LCD steps alright... I ...

Hello fellow Printers! For the most part my printer has been behaving quite nicely, except I'm having some issues with the heated bed. It's always had trouble getting above 82 C (as in it doesn't get that high, and eventually just stops heating and leaves a "Killed" message on the LCD). Today ...

Hello fellow Printers! I got my printer up and running with very few issues, and my first two prints (the fan holders) turned out amazingly well for first prints. That being said, I noticed in both cases that there were small "cuts" every once in a while scattered through the part. [img]http://i62 ...