Welcome to the SeeMeCNC Community

Yes!! I'm super excited for what is to come, but i still can't find polygonhell's part. If anyone could send me the .stl for it or something that would be great! I'v tried tweaking many settings, but I still can't push it out at more than 20-30 mm/s speeds without the filament coming out the side of ...

I'd start by verifying the temperature of the nozzle with a thermocouple, I think the current SeeMeCNC hotends are reporting higher than actual readings. However I could extrude ABS down to about 235C with mine. If you can extrude by hand then the issue is likely slipping filament. What rate are ...

Alright, this isn't as easy as i thought it was going to be :? and with this being my first 3d printer i need some serious assistance: 1. When i start the print, barely any plastic comes out (it comes out really slowly and bunches up on the nozzle) -I tried a higher temp up to 245 degrees but i don ...

BTW what is the nozzle size?

bhesson

This is a good calibration guide, including the center too high/low correction http://minow.blogspot.com/?m=0 Thanks, this guide worked perfectly! And just last night the replacement parts came in the mail, i have hooked averything up at this point and when i get back home today i will run the ...

Thanks! I don't know why i didn't think of that but changing the pin in the firmware worked perfectly! Now i just have to wait for my new parts. (waiting on USPS mail for three weeks now) One more thing, when calibrating i can get the three carriages calibrated together using the end-stop screws ...

This is my first 3d printer after following the technology for two years, and i'm so glad to finally own one!!! After a thermistor malfunction and an overheated (the PEEK and teflon melted) hot-end, I needed a few replacement parts which the SeeMeCNC team happily provided to me free of charge ...