Welcome to the SeeMeCNC Community

here it is: http://www.thingiverse.com/thing:512442

I Was printing this with 2 shells and infill. I thing it will be enought to have only 1 shell and 0 infill, this can decrease weight a little bit more, I can give you a file, but in some cases close to the edge of HB it is quite close to the rods. This is made for 40x40 mm common 12 V fun, runs ...

Thanks for your feedback.
Question is, is it worth to make this upgrade?
Is there any big difference in quality of prints??
I am asking, because I did just a few prints, and surface seems quite nice...
Yes with magnetic rods, its easier to change, clean effector...Do you have magnetic rods?

I did some modification today. I thing cooling from all 3 sides should result more consistent prints.

I had used silon wire, went trought tower. Attached wires taped on the end with silon, and then just went back up to tower binded on this silon leading wire... All 3 towers at 1st try.

This guy is preparing this: http://3dprintingindustry.com/2014/09/0 ... ment-webs/
I suggest to wait..

Is final length important? I mean, if it will be little bit shorter of 1-2 cm, should I correct this somewhere? Does it affect something?

Hello everyone, Do you know where to buy magnetic rods kit for max v2? Efector, no needed. This seems wuite great, but too expensive: http://www.spiderbot.eu/en/shop/upgrades/magnetic-rod-end-tss-upgrade-detail.html I need just carbon tubes, magnets and steel balls, all other parts will be printed ...

Hi everyone, I am happy to introduce here. I am in 3DP for 3 years, I have 2 MB2, 1 UM2, and finaly we had decided to build 1 RMV2. I did it in 20 hours, and we are really impressed! Thats great to know your 3D printer, how it works deeply. WE DO MOSTLY OUR OPEN DESIGN PROJECT OF PRINTABLE BIRD ...