Welcome to the SeeMeCNC Community

I undone all adjustments to offset except those in Firmware and noticed that it got worse... by exactly double. I have set Extruder 1 as Left Hand, as you look at the printer and Extruder 2 as Right Hand side, I've reversed the signs for EXT0 and 1 offsets in firmware and I'm just waiting on some ...

Hi, I've used this particular thread to get my printer ready for printing with an E3D Chimera. All physical tweaking is done, Nozzles levelled and temperatures calibrated nicely. I even set the LCD to display the 3 temps. [img]https://www.dropbox.com/s/jymyl4fxgtvn6uv/2015-04-22%2016.31.22.jpg?dl=0 ...

I have failed to completly empty the nozzle so I have ordered a replacement. The PTFE Liner inside he hotend seems to be sitting nicely and I don't think the assembly is overtight or too loose either. Seems as though the very tip, last 3mm of the nozzle is blocked or maybe too cold. Can I use a ...

I followed the thermistor calibration guide and I got the hotend heating to pretty much exactly 225c measured by the thermistor and from a multimeter with a thermocouple. Feeling happy I put everything back together and then still no extrusion. Everything from the extruder to just before the nozzle ...

I have a Rostock Max v2 with standard hot end and everything was printing fine from the start. First print or 2 failed simply due to bed adhesion, (Prints came loose half way through). After switching to ABS slurry to hold everything down I was getting good prints. I even managed to print at .15 ...