Welcome to the SeeMeCNC Community

So I have been printing very happily for several months now and have hit a snag. I printed a model this morning and then made a z total z height adjustment and tried to print again. The ordered hot end temp did not get sent to the printer when I hit the start print button. I stopped the print and ...

I prefer Bubblehead, and Eaglez is right.......1 tentacle, 50 foot in diameter.......and a steely grip that won't quit.

Hey Guys, My name is Tim and I am recently retired from the Navy after 23 years on Submarines. I have an addiction to RC warships, especially RC submarines. Go figure......anyway I am an electronics technician by trade and have some drafting and 3d modeling experience. I wanted to combine my talents ...

Hey Guys, My name is Tim and I am recently retired from the Navy after 23 years on Submarines. I have an addiction to RC warships, especially RC submarines. Go figure......anyway I am an electronics technician by trade and have some drafting and 3d modeling experience. I wanted to combine my talents ...

I am also having this issue, and am noticing that my prints are sloping in the direction of the slipping rods. Has anyone else notice a reduction in print fidelity due to this? I was thinking about eliminating the plastic clips and putting wheel collars on each end of the rod like I would do for my ...