Welcome to the SeeMeCNC Community

This one almost fits the v2. I printed it out in ABS but the holes don't quite line up. I was just going to drill it to suit. http://repables.com/r/170/ These LEDs look like an almost perfect fit http://www.amazon.com/gp/product/B007Q946RQ Both will require a little tweaking to clear the layer fan ...

Are you sure its not moving? Generally I've found it takes about 3 clicks from Repetier to see filament extrude from the hot end when it first gets started. You can increase extrude from the manual setting to 20mm or even 30mm and then watch the results. If its not moving check your connections to ...

Okay, something is very wrong with my extruder. When I try to feed filament it clicks and retracts, clicks then retracts, sounds like it's jamming. It never feeds the filament. Hold the red lever down and push your filament till you see it start to come out of the hotend. I dont think you are ...

:D I was very close to lucky!! But no, a little too snug. I hope it's okay that I have the bed and hotend heated (55c/190c) while doing the calibration... never instructed to turn them back on, but I'm assuming. I'm sure that was just an oversight in the guide. You definitely want to make the ...

I finished my build this morning. Just going through the calibrations. I'm a little bit confused by this part of the instructions: In order to make sure that each axis is higher than the three points listed above, I want you to position the machine using these commands: G28 G0 Z5 X0 Y90 F3500 Click ...

I completed my build about a week ago. My extruder feeder looks about like Atoff's does and I did question it but decided to take a leap of faith and installed it and its working just fine. geneb thank you so much for your awesome assembly guide. Have you made any prints yet and if so, how are they ...

I completed my build about a week ago. My extruder feeder looks about like Atoff's does and I did question it but decided to take a leap of faith and installed it and its working just fine.

geneb thank you so much for your awesome assembly guide.