Welcome to the SeeMeCNC Community

Im using ABS (buy from seemecnc) print with .1mm layer height. after printing only sanding the surface (we never used acetone). then primed surface (with primer for plastic). Then painting with acrylic paints. after all we cover the glassy varnish.

Hello. We (me with my girlfriend ) modeling, printing and painting some this stuff. Enjoy
[img]http://cs619828.vk.me/v619828033/175fd/ByJn46N217g.jpg[/img]
http://www.youtube.com/watch?v=lM8yzL4N_3I

i fix jerks (head hit the cooled unevenly plastic). But now i have another problem with calibration. If i set height of calib. screw that they printed the outer radius (as badly as in the picture) I have a problem with center height, Nozzle very low or very high (i try change radius from 129.50 ...

Hello. I printed about a month without any problems. Today start printing and head began to move jerkily in some places. Outside square prints Normal. but when there is a filling is about a 1 cm from the edge begins pull is enough and the influx of plastic up. for the first 7-9 layers printer ...

This printer will be open as Rostok max (drawings for melomine, CAD model, etc.) ??

Hello. installing them I was a little confused the direction of the eye. but I think it does not matter(now i have gray plastic on right side and black on left side). have a small question regarding tightening gray sleeves. if there is insufficient tighten that one of the wheels with a black sleeve ...

Hello got my kit. but unfortunately until reach Russia broke borosilicate glass. it with special properties or simple? The company in my city offer borosilicate glass 4 mm thick instead of 3 that came in the kit. (price $ 95 )
Does it will approach?
(sorry if my english too bad xD )