Search found 3 matches
- Fri Nov 21, 2014 6:39 pm
- Forum: Troubleshooting
- Topic: Hot end not coming up to temperature before printing
- Replies: 1
- Views: 2048
Hot end not coming up to temperature before printing
Recently, the hot end of my Orion Delta is not consistently coming up to the target temperature during the initial heat cycle. I have it set at 225 and it just stops heating at a few degrees cooler. I can get it to get up the 225 by manually adjusting the temp to a few degrees hotter (230) and then ...
- Sat May 03, 2014 7:55 pm
- Forum: New Member introduction
- Topic: Hello - I'm John from Florence, Oregon
- Replies: 3
- Views: 4584
Re: Hello - I'm John from Florence, Oregon
Thank you for the link to the .ini files and the information on PLA. I will try some more of the settings when I reload with PLA again.
- Sat Apr 26, 2014 6:35 pm
- Forum: New Member introduction
- Topic: Hello - I'm John from Florence, Oregon
- Replies: 3
- Views: 4584
Hello - I'm John from Florence, Oregon
I purchased the Orion Delta and three filament types (ABS, PLA and Bridge) to have something to learn with. I use TurboCan v21Pro to develop prints and am learning that as I go. Initial prints were satisfactory with ABS, went to PLA and the first couple were okay, but then they started getting ...