Welcome to the SeeMeCNC Community

Hello, The usb cable works fine -- I can without any problem connect to the printer and send him files for a print job. The selected device within Arduino is: Arduino Mega 2560 Port: /dev/tty.usbmodem411 Whilst searching in the internet I've found some postings with the same "avrdude stk500v2 ...

Hello, Here is my complete config: OSX 10.9.4 Repetier Host MAC 0.56 Arduino 1.05 Orion: FW 0.83 My settings within Repetier Host: Port: usbmodem411 Baud rate: 250000 Stop bits: 1 Parity: None Transfer: Autodetect Cache Size: 127 There is no problem to connect to the Orion Printer via Repetier Host ...

Hello,

Did somebody successfully updated the Orion firmware to .91 using a OSX (10.6.8)? If yes - please let me know it. I get always a time out error. But the connection for a print via USB is working fine....

Hello,

My printer has .83 installed. I've tried to ugprade to .91 according to the video which is available, but I only get a timeout message. I posted this problem within the ORION section.

Dietmar

Hello, After a long way of ongoing problems with an other so called "ready to use" 3D printer I decided to buy another one. After looking around for a longer time, I finally decided to buy a CNC Orion 3D printer. The setup was very easy and I think it took less than 30 minutes before I've started my ...

Hello, I did not remove the board - it is installed in the printer and the printer is switched on. As I wrote I can successfully connect to the printer via repetier host. But when I try to update the firmware I get always these time out errors.... Is the "AVR ISP" the correct programmer? Is it ...

Hello, When I try to print 4-6 copies of the parts at the same time, the printer very often stops printing in the middle of the print (all prints via SD card). I red somewhere that upgrading to firmware 0.91 should solve it. I use OSX 10.6.8 and Repetier Host 0.56 - I can via Repetier Host ...

Hello,

The board inside my Orion is a version 1.2e -- Does it require the jumper mod or not?

I've send all three emails with the following header: Static Jumper Mod for RAMBO and included the order number and address. My board is 1.2 version -- This is what is printed on the board. Ok - I was not aware of all the additional revisions. I'll try to take a picture of the part with the version ...

Hello,

I looks that I got one of last ORION printers without the static jumper mod. I've send since 17. February 3 emails to their support, but so far I got no reaction from them nor the static jumper. Does anybody got the static jumper since they announced it on the homepage?

@ int2str

I imported your settings - the nozzle diameter is set to 0.40 mm -- Are you using a different nozzle on your Orion printer or does this setting get a printer quality than the standard 0.50mm ??