Welcome to the SeeMeCNC Community

Have a problem lowering my extruder head - when i go to lower it using the manual commands it lowers really slowly - thought it may be a problem with the motor but it still rises back up to the end stops at a normal rate. Also results when calibrating were odd as explained below command G0 Z5 X77.94 ...

Haha well that went a bit off track Still have the problem lowering my extruder head - when i go to lower it using the manual commands it lowers really slowly - though it may be a problem with the motor but it still rises back up to the end stops at a normal rate and as explained below from my ...

Finally managed to solve the problem with replacing the power supply. Now i have another issue though. Regarding this command G0 Z5 X77.94 Y-45 F3500 When the printer lowers down to the other two positions (G0 Z5 X-77.94 Y-45 F3500 and G0 Z5 X0 Y90 F3500) it moves rapidly When it lowers to the G0 Z5 ...

Screen shot

I have run the checks on the end stops and they seam to all be functioning fine - but when i go to run the G28 it starts for a short period of time then stops and wont move past that point. The Z value in the manual control panel changes from 0 to 360.95 When i connect it also says SD init fail - if ...

Also When i go to update Arduino i get this message

core.a(main.cpp.o): In function `main':
E:\Program Files (x86)\Arduino\hardware\arduino\cores\arduino/main.cpp:5: undefined reference to `setup'
E:\Program Files (x86)\Arduino\hardware\arduino\cores\arduino/main.cpp:15: undefined reference to `loop'

Hello Trying to setup my rostock max printer and having trouble when it comes to the G28 test to check the correct wiring of the stepper motors - when i send this command the motors made a small movement then stopped - when i turned the power switch off then on again they made another small shift ...