Welcome to the SeeMeCNC Community

If I want to change the filament spool to print an object in another color, I try to retract the filamant completely out of the extruder by hand or via rephost. In both cases the last part of the filament gets stuck in the extruder and i have to disassemble the extruder to remove the last part of ...

Ok here are the results after calibration; Multiplier is 0.917. The wall thickness is 0.55mm and the size of the box is 19,93 x 19.93 x 10.08 mm. Below 2 pictures of the printed box after calibration. Seems to me quite well. what is your opinion?

Hi Guys, Yeahhh that was the solution. I printed the box with the parameters all set to 0.55 and the multiplier to 1. The wall thicknes is now 0.61 and the sixe of the box is 19.93x19.98x10.08 mm. Also the bottom layers looks much better. Thank you all:) I will continue the calibartion and will let ...

They are alle zero, see screen print and also the extruder settings

Hi Cleveralias, I am using Slic3r version 0.9.10b. I see only a raft parameter at the support material and it is 0 layers. Where can I find the settling for the first layer extrusion width? But the main issue is the wall thickness when I print a calibration box. I have to set the multiplier to 0.618 ...

I checked the measures of the printed box and it is 10.17x19.57x19,6 mm. I also printed a box with a multiplier of 1.1 and the bottom looks better. The size of that box is 9,83x20.08x19.98. I also checked the calibration of the z-axis (with hetead bed and hot end @ print temperature) and all towers ...

Hi, I finished my rostock build and made a few prints which were looking quite oke. I started to calibrate the extruder. The first step calibrating the e-stepper; heat the extruder and feed 5 cm ABS and measure the actual length en change the e-steps, feed again until the actual movement is also 5 ...

Thank you for the responses. I just sent an email to CNC. I will keep you informed!

MSURunner wrote:When you use the rotary dial, does it appear to move through the menus/options (even though you can only see the little bit in the top left corner)? If so, I'd say it appears your LCD is defective...

yes it is, I see the tekst changing on the left top corner as on the photo

Hi, I build the Rostock max. At the start the LCD was working. After a few days, just after the calibration process, the LCD stopped working. I checked the fuses, the flat cables, uploaded the firmware, the adapter board. Everything seems to be ok. About two days ago the LCD was working again for a ...

Hi all, My name is Frank and I am living in Almere in the Netherlands. It is about 20 miles from Amsterdam. I am new to 3D printing. After reading a lot about 3D printing and 3D printers I ordered a Rostock Max. It is currently located at the customer services in the Netherlands. I am looking ...