First non-fan shroud printing project I tried was this tool/glue stick organizer for BD: http://www.thingiverse.com/thing:1140304" onclick="window.open(this.href);return false;
It took about 5 hours to run out of 1.7mm PLA, came out really nice. I then painted it black & green to match BD's color scheme... Looks factory-fresh!
Organizer
- The Rigger
- Prints-a-lot
- Posts: 34
- Joined: Wed Feb 17, 2016 6:34 pm
- Location: Michigan, unless I'm on tour
Organizer
Last edited by The Rigger on Sat Feb 20, 2016 5:22 pm, edited 2 times in total.
-Dave
Central Michigan, USA
(unless I'm at work)
Central Michigan, USA
(unless I'm at work)
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Organizer
Looks nice! Good job and thanks for the picture!
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”
- thedoble
- Printmaster!
- Posts: 131
- Joined: Fri Dec 25, 2015 8:32 pm
- Location: Brisbane, Australia
- Contact:
Re: Organizer
Nice, I printed one of these but it doesn't fit the australian 'uhu' gluesticks
I should have measured before I printed!
I should have measured before I printed!
Smoke me a kipper, I'll be back for breakfast.
Re: Organizer
Was that a sly "Everything is bigger in Australia!" joke?
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
- The Rigger
- Prints-a-lot
- Posts: 34
- Joined: Wed Feb 17, 2016 6:34 pm
- Location: Michigan, unless I'm on tour
Re: Organizer
Not bigger; uʍop-ǝpısdn.geneb wrote:Was that a sly "Everything is bigger in Australia!" joke?
-Dave
Central Michigan, USA
(unless I'm at work)
Central Michigan, USA
(unless I'm at work)