Orion print

Navkram · Post by **Navkram** » Sat Dec 28, 2013 10:04 am

Post by **Eaglezsoar** » Sat Dec 28, 2013 10:12 am

Very Cool!

neurascenic · Post by **neurascenic** » Sat Dec 28, 2013 10:38 am

Nav, That is very cool! Single print? or assembled?

barry99705 · Post by **barry99705** » Sat Dec 28, 2013 11:16 am

neurascenic wrote:Nav, That is very cool! Single print? or assembled?

Has to be assembled. It's wider than the build platform.

Navkram · Post by **Navkram** » Sat Dec 28, 2013 3:20 pm

assembled, changed the springs to print better without support.
thingiverse... http://www.thingiverse.com/thing:127721

barry99705 · Post by **barry99705** » Sat Dec 28, 2013 5:50 pm

Now the even bigger question. Does it work?

Navkram · Post by **Navkram** » Sat Dec 28, 2013 6:07 pm

yes it does work. not sure what you can catch but it does snap pretty good.
http://youtu.be/fNf977apJPU

barry99705 · Post by **barry99705** » Sat Dec 28, 2013 7:04 pm

That's just cool!

SDI · Post by **SDI** » Sat Dec 28, 2013 7:54 pm

wow, scary!

nicely done!

Welcome to the SeeMeCNC Community