Hi Guys, just finished the droplit build and I'm having problems connecting. I'm pretty sure I got it configured right but get invalid printer response in the connect window of Mattercontrol. When I hit connect, the whining from the motor pauses while the connection is attempted, then resumes after failing. The motor spindle is also locked up. Any Ideas ?
regards, Dale.
Connect to printer problem
-
- ULTIMATE 3D JEDI
- Posts: 1409
- Joined: Sun May 11, 2014 6:18 pm
Re: Connect to printer problem
I wasn't aware that you could use Mattercontrol with the Droplit printer.
R-Max V2
Eris
Folger Tech FT-5 R2
Eris
Folger Tech FT-5 R2
Re: Connect to printer problem
... you can't. It might move the Z axis some, but you certainly can't use it to print with.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
-
- Plasticator
- Posts: 5
- Joined: Mon Jan 18, 2016 10:53 am
Re: Connect to printer problem
Thanks, so what should I be using for slicing and printing ?
-
- Plasticator
- Posts: 5
- Joined: Mon Jan 18, 2016 10:53 am
Re: Connect to printer problem
Ok so I can upload stepper speed control from arduino 1.6.7 and the led on the board starts flashing with simultaneous whining from the motor, but no rotation. I know I wired it up correctly so it makes me think of a defective motor ? maybe