Page 1 of 1

24V on the Azteeg X3 Pro?

Posted: Fri Jul 24, 2015 12:10 pm
by PeteD
I'm about to upgrade my Rostock MAX v2 to handle 3 extruders/hotends. Part of the upgrade is to replace the RAMBo with an Azteeg X3 Pro. I'm thinking up upgrading the PSU to a 24V PSU as well. The Azteeg is advertised as allowing a 12V-24V input. Has anyone actually run 24V through an Azteeg X3 Pro? Are there any issues with doing this that I should watch out for?

Re: 24V on the Azteeg X3 Pro?

Posted: Fri Jul 24, 2015 6:20 pm
by Renha
I am using AX3P with 24V, and I haven't any issues.

Re: 24V on the Azteeg X3 Pro?

Posted: Mon Jul 27, 2015 10:21 am
by PeteD
Are you using an SSR for the heated bed?

Re: 24V on the Azteeg X3 Pro?

Posted: Tue Jul 28, 2015 3:32 am
by Renha
Nope, pure 24V, input and output.

Re: 24V on the Azteeg X3 Pro?

Posted: Tue Jul 28, 2015 10:18 am
by PeteD
What is the wattage of your 24V power supply?

Re: 24V on the Azteeg X3 Pro?

Posted: Tue Jul 28, 2015 10:23 am
by Renha
750W meanwell

Re: 24V on the Azteeg X3 Pro?

Posted: Tue Jul 28, 2015 11:16 am
by 0110-m-p
Which heated bed revision? Do you know the resistance of it?

Re: 24V on the Azteeg X3 Pro?

Posted: Tue Jul 28, 2015 11:23 am
by PeteD
That is awesome! you don't have any additional cooling on the board?

Re: 24V on the Azteeg X3 Pro?

Posted: Thu Jul 30, 2015 3:11 am
by Renha
PeteD wrote:That is awesome! you don't have any additional cooling on the board?

I had two 12v pumps in series for water cooling, but lately I have bought 24v fan for air-cooling

Re: 24V on the Azteeg X3 Pro?

Posted: Thu Jul 30, 2015 10:41 pm
by Nylocke
I am also running 24V through my X3 Pro. Its a 360 Watt one I got from Lulzbot. Running the bed and steppers on 24V. Still doing the hotend/other bits on 12V, since they aren't rated/designed for 24V.