SE300 with Azteeg X3 Pro?

Post Reply
Posts: 1
Joined: Thu Oct 31, 2019 3:23 pm

SE300 with Azteeg X3 Pro?

Post by PixelGl1tch »

Has anyone successfully connected the SE300 to the Azteeg X3 Pro? If so, what is the pin configuration? I can source 3.3v power from my raspberry pi sitting next to my printer, so that part is not an issue. I am unsure where to wire the Probe Trigger and Probe Serial wires to and any necessary post-configuration to the firmware. I have a Rostock Max running Repetier 1.0.3, any help would be much appreciated.
Posts: 5370
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA

Re: SE300 with Azteeg X3 Pro?

Post by geneb »

The main feature of the SE300 is the strain gauge that's built into the PCB. Unfortunately, there's no 8 bit firmware capable of handling the output (that I'm aware of). If you want to update your Rostock MAX, an SE300, assembled wiring whip, and a Duet WiFi will do the job nicely.

Delta Power!
Defeat the Cartesian Agenda! - 80-0007, The only one of its kind. - Technical and Simulator Projects
Post Reply

Return to “Azteeg X3 and X3 Pro”