I think you should add a few more maximum bed sizes for the literature. I constantly hear that an Orion can only do a 4.25" square maximum. No one thinks about the rectangle size, so i think you are losing some customers.
I think you should add a few:
1) 4.25 x 4.25 square
2) 4.0 x 6.0 rectangle
3) 6.25 diameter circle
I have been making alot of iPhone 6 cases, and most people think the Orion can't do that size.
Orion Consumer specs for bed size
-
- Printmaster!
- Posts: 171
- Joined: Tue Apr 22, 2014 10:00 pm
- Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: Orion Consumer specs for bed size
I'd assume that the reasoning behind their published spec is to have a number comparable to all of SeeMe's Cartesian competitors that can only do rectangular build areas. Right now the website says:
6" diameter by over 9" tall cylindrical build volume (appx. 175 cubic inches)
5" Square by 9" tall box shaped build volume
Which covers 2/3 of the bases that you touch on, even though the numbers are slightly different.
6" diameter by over 9" tall cylindrical build volume (appx. 175 cubic inches)
5" Square by 9" tall box shaped build volume
Which covers 2/3 of the bases that you touch on, even though the numbers are slightly different.
-
- Printmaster!
- Posts: 171
- Joined: Tue Apr 22, 2014 10:00 pm
Re: Orion Consumer specs for bed size
I was thinking more of this one:
Build Area
Maximum Printable X/Y Area 6" Diameter (150mm)
Maximum Printable Square Size 4 1/8"" (106mm)
Maximum Printable Z Height 9 1/4" (235mm)
Build Area
Maximum Printable X/Y Area 6" Diameter (150mm)
Maximum Printable Square Size 4 1/8"" (106mm)
Maximum Printable Z Height 9 1/4" (235mm)