Fan not shutting off

A pre-assembled Delta Printer that can print a 6" cube 8" tall!
Post Reply
Jsmb768ypl
Plasticator
Posts: 7
Joined: Sun Feb 07, 2016 8:37 pm

Fan not shutting off

Post by Jsmb768ypl »

Okay so after a print finishes and the tower goes to home the fan still runs and makes this annoying whining noise how can i make it so the fan shuts off when the print is done?
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Fan not shutting off

Post by geneb »

When the hot end drops below 60C, the fan will shut off automatically.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Jsmb768ypl
Plasticator
Posts: 7
Joined: Sun Feb 07, 2016 8:37 pm

Re: Fan not shutting off

Post by Jsmb768ypl »

it didn't it was running all night after the print finished.
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Fan not shutting off

Post by geneb »

Are you referring to the PEEK fan? It will shut off below 60C.

If you're talking about the RAMBo or power supply fans, those will run as long as the power switch is on.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “ORION”