Printing large print.
-
printer999
- Prints-a-lot
- Posts: 26
- Joined: Sun Jan 26, 2014 3:06 pm
Printing large print.
Hey Guys I am thinking about doing my first very long and large print. It would take over 24 hours and require at least $8 for part of it. I was looking at it however before I got to printing and wasnt sure about the size. Is this too big to print off on a orion?
- Attachments
-
- body.STL
- Its a trumpet mainbody
- (2.01 MiB) Downloaded 244 times
Re: Printing large print.
yes, it is definitely to tall and way to wide.
Orion to Cartesian http://forum.seemecnc.com/viewtopic.php?f=59&t=7808" onclick="window.open(this.href);return false;
-
printer999
- Prints-a-lot
- Posts: 26
- Joined: Sun Jan 26, 2014 3:06 pm
Re: Printing large print.
well if you put it vertical I think it is just a little too large.
Re: Printing large print.
True. However you really have to watch the height. The Orion will not stop once it hits the limit switchs and will try and drive through the top. Big mess. You can half the model and glue it.printer999 wrote:well if you put it vertical I think it is just a little too large.
Orion to Cartesian http://forum.seemecnc.com/viewtopic.php?f=59&t=7808" onclick="window.open(this.href);return false;
-
joecnc2006
- Printmaster!
- Posts: 150
- Joined: Tue May 14, 2013 11:42 am
Re: Printing large print.
I would make the body separate them make the pipes slide on similar to pvc piping, and make the middle support overlap and bolt together to hold into place.
Joe
http://www.joescnc.com" onclick="window.open(this.href);return false;
http://www.joescnc.com" onclick="window.open(this.href);return false;