I've been using Elmers glue exclusively from day 1 with my ORION. It's been working great for many hours and has never given me problems...
Well, yesterday it happened - the glas plate broke.
After printing a part and letting it cool on the plate, I gently pried the part off (using a plastic scraper) and part of the glass plate stayed attached to the part....
Didn't think this would happen with Elmers only - alas, it did.
Broken glass plate
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Broken glass plate
Sorry to hear that and it is hard to believe it happened with Elmers glue.int2str wrote:I've been using Elmers glue exclusively from day 1 with my ORION. It's been working great for many hours and has never given me problems...
Well, yesterday it happened - the glas plate broke.
After printing a part and letting it cool on the plate, I gently pried the part off (using a plastic scraper) and part of the glass plate stayed attached to the part....
Didn't think this would happen with Elmers only - alas, it did.
Very unusual but it is what it is. I've been lucky so far with my hair spray but my day will come.
Again, I am sorry that this happened to you and I know the sickening feeling in the pit of your stomach when something like this happens.
Better luck in the future.
- Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: Broken glass plate
Did you break a cheap piece of window glass, or was this a piece of boro glass?
Re: Broken glass plate
Can I ask what material you were printing with? I remember seeing someone break their borosilicate by printing a very large nylon part...
Re: Broken glass plate
Whatever comes with the ORION.Jimustanguitar wrote:Did you break a cheap piece of window glass, or was this a piece of boro glass?
ABS. I've only ever printed ABS on this machine.Glacian22 wrote:Can I ask what material you were printing with?
Re: Broken glass plate
When you cleaned the plate before, what did you use? I found that after numerous prints the glass just goes, I was thinking about sourcing a 1/4" or 3/8" tempered glass piece from Binswanger and seeing how it would hold up. My personal feeling is that the Boro glass that comes with the Orion is a bit too thin.