Filaflex?
Re: Filaflex?
How long is the bowden on the Orion ? Is it much shorter than a top loaded Max ?
- Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: Filaflex?
I'm hoping that one of us "Air-Struder" guys stumbles upon a sample. If long bowden tubes are problematic with this material it probably could work with a short 2? or 3" tube...
Re: Filaflex?
I'll check that, I'll find a way to lower my extruder and try again with a shorter bowden... there is no way I would give up on my filaflex spool !!
Re: Filaflex?
Hi
i am new here
i have been printing with NinjaFlex since 3 days my printer is the Orion no mods
im printing with 10 mm speed and 230C
the last print is still running for 14 hours all the layers looks very good (still about 8 hours left)
but the main issue is the oozing it is something i could not stop
i am new here
i have been printing with NinjaFlex since 3 days my printer is the Orion no mods
im printing with 10 mm speed and 230C
the last print is still running for 14 hours all the layers looks very good (still about 8 hours left)
but the main issue is the oozing it is something i could not stop
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Filaflex?
Try turning the temperature down to 225.mrbdrm wrote:Hi
i am new here
i have been printing with NinjaFlex since 3 days my printer is the Orion no mods
im printing with 10 mm speed and 230C
the last print is still running for 14 hours all the layers looks very good (still about 8 hours left)
but the main issue is the oozing it is something i could not stop
Re: Filaflex?
Filaflex will expend a lot while heating up. They had many clogging issues while trying to achieve the 1.75mm Filaflex.
That is why, the filaflex filament is roughly 1.5mm, instead of 1.75mm.
To me, it only makes it more flexible and difficult to drive through a bowden tube.
What is Ninjaflex diameter ?
That is why, the filaflex filament is roughly 1.5mm, instead of 1.75mm.
To me, it only makes it more flexible and difficult to drive through a bowden tube.
What is Ninjaflex diameter ?