The machines...

[Justin@Saturday]

I posted this in the introductions already, but figured I'd share here as well. It seems like the right place.

Rostock Max v2 (the wiring is all outside the machine - so I can tinker with alternative boards, etc) and a uPrint SE Plus.

[BONE]

I should of done wiring on the outside also. I'd be fine with a separate conduit that has all the wires hidden inside. Running the wire inside the extrusion was such a pain in the a$$.

[Justin@Saturday]

It'd be awesome if the guys at SeeMeCNC would modify the top and bottom wood plates to include a flat for a bit of Panduit (...or whoever...) conduit running top to bottom. Even if it was an optional sort of thing.

[geneb]

Check out the alternate cable routing method I show in the back of the v1 manual.

g.