Printing Live! join chat, yadda yadda yadda
http://www.ustream.tv/channel/guanu/
Guanu
I'm Live again.. Ramps + PLA... 0.0145" nozzle
Re: I'm Live again.. Ramps + PLA... 0.0145" nozzle
6/26 and I'm printing... switched to marlin firmware on the ramps setup, much nicer.. printing hopefully final version of my LM8UU x-carrage.. printed it last night, but printed it a little too fast... slowed it down to 35mm/sec with 55mm/sec infill.. should come out nicer
http://www.ustream.tv/channel/guanu
Guanu
http://www.ustream.tv/channel/guanu
Guanu