I'm Live again.. Ramps + PLA... 0.0145" nozzle

Post your streaming time/info here, so people know when you're printing live
Post Reply
guanu
SeeMeCNC Staff
Posts: 397
Joined: Mon Mar 26, 2012 1:54 pm

I'm Live again.. Ramps + PLA... 0.0145" nozzle

Post by guanu »

Printing Live! join chat, yadda yadda yadda

http://www.ustream.tv/channel/guanu/

Guanu

guanu
SeeMeCNC Staff
Posts: 397
Joined: Mon Mar 26, 2012 1:54 pm

Re: I'm Live again.. Ramps + PLA... 0.0145" nozzle

Post by guanu »

6/26 and I'm printing... switched to marlin firmware on the ramps setup, much nicer.. printing hopefully final version of my LM8UU x-carrage.. printed it last night, but printed it a little too fast... slowed it down to 35mm/sec with 55mm/sec infill.. should come out nicer

http://www.ustream.tv/channel/guanu

Guanu

Post Reply

Return to “Live Stream Announcments”