Page 1 of 1
Tower of Pi attempt
Posted: Sun Jun 08, 2014 1:21 pm
by cweiss
I'll be trying to print the Tower of Pi
http://www.thingiverse.com/thing:271769 Today (6/8).
Live stream from Dropcam:
http://dropc.am/p/rostock
It's a 13hr print, here's to hoping it doesn't screw up!
Re: Tower of Pi attempt
Posted: Sun Jun 08, 2014 8:00 pm
by RAMTechRob
Excellent clarity on that video. Looks good so far.
Re: Tower of Pi attempt
Posted: Sun Jun 08, 2014 8:11 pm
by cweiss
This is just cruel and unusual punishment on the Bowden extruder. It has to retract a bit between each move between character legs. Sounds like a pneumatic nail gun. There's definitely a bad corner to the print, I'm guessing one of the cassettes is sloppy.
Re: Tower of Pi attempt
Posted: Sun Jun 08, 2014 9:02 pm
by Tinyhead
Nice job. Looks like minimal stringing too.