Page 1 of 1

Organizer

Posted: Fri Feb 19, 2016 3:09 pm
by The Rigger
First non-fan shroud printing project I tried was this tool/glue stick organizer for BD: http://www.thingiverse.com/thing:1140304

It took about 5 hours to run out of 1.7mm PLA, came out really nice. I then painted it black & green to match BD's color scheme... Looks factory-fresh!

IMG_4663.JPG
MaxTray.JPG

Re: Organizer

Posted: Fri Feb 19, 2016 3:20 pm
by Eaglezsoar
Looks nice! Good job and thanks for the picture!

Re: Organizer

Posted: Sun Feb 21, 2016 12:49 am
by thedoble
Nice, I printed one of these but it doesn't fit the australian 'uhu' gluesticks :(

I should have measured before I printed!

Re: Organizer

Posted: Sun Feb 21, 2016 10:36 am
by geneb
Was that a sly "Everything is bigger in Australia!" joke? :D

g.

Re: Organizer

Posted: Sun Feb 21, 2016 1:25 pm
by The Rigger
geneb wrote:Was that a sly "Everything is bigger in Australia!" joke? :D


Not bigger; uʍop-ǝpısdn.