Rostock Max V3 wont auto calibrate

Having a problem? Post it here and someone will be along shortly to help
Post Reply
mogge
Noob
Posts: 1
Joined: Mon Jan 25, 2016 5:43 pm

Rostock Max V3 wont auto calibrate

Post by mogge »

Everything was working fine printer wise. Was getting some bad prints .Nozzle seemed clogged with PTFE, replaced it, went to full calibrate using the auto calibration, wont calibrate. Goes back to the main screen (temps, version etc) and says Insert SD Card. Bought a new HE280 hotend assembly (complete) replaced it on my machine. Tried to full calibrate again, same behavior. I made sure the cables were seated correctly. Any ideas of what else to try?
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Rostock Max V3 wont auto calibrate

Post by geneb »

(not being sarcastic) Did you insert a known good SD card?

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “Troubleshooting”