Page 1 of 1

Not connecting to round circles

Posted: Wed Aug 15, 2018 10:22 pm
by brianmichalk
Rmax V3.2. I can't seem to get the interior walls of a screw hole to attach properly. I've changed flow rate, line width, speeds and temperatures, but I think this basically comes down to a slicing problem. Does anyone have any ideas?


Re: Not connecting to round circles

Posted: Sun Aug 19, 2018 10:59 am
by IMBoring25
I see a few places that make it look like you might be having difficulty restarting extrusion after retractions. Which hot end are you using and what are your retraction settings?