Not connecting to round circles

Having a problem? Post it here and someone will be along shortly to help
Post Reply
Posts: 40
Joined: Fri Aug 12, 2016 3:20 pm

Not connecting to round circles

Post by brianmichalk »

Rmax V3.2. I can't seem to get the interior walls of a screw hole to attach properly. I've changed flow rate, line width, speeds and temperatures, but I think this basically comes down to a slicing problem. Does anyone have any ideas?

Posts: 616
Joined: Wed Mar 18, 2015 1:11 am

Re: Not connecting to round circles

Post by IMBoring25 »

I see a few places that make it look like you might be having difficulty restarting extrusion after retractions. Which hot end are you using and what are your retraction settings?
Post Reply

Return to “Troubleshooting”