V1 Max Post Ball Cup Arm & Carriage Issues
Posted: Mon Dec 05, 2016 3:44 am
Hello All,
I am not sure what I did wrong but my trusty V1 is no longer moving the end effector to the edge of the bed. I recently upgraded my V1 arms ball cups as well as the injection molded carriages. In addition I grabbed the most recent firmware off the master path on Github. The problem I am having is that when I perform the tower alignment process the end effector center will only get to within ~=70mm of the edged of the bed. I updated both my Diagonal Rod Length (290.8mm) and Horizontal Rod Radius (140mm). Finally I am still using Repitier host, but I have always used it for calibration.
Any help would be greatly appreciated.
-Christian79
I am not sure what I did wrong but my trusty V1 is no longer moving the end effector to the edge of the bed. I recently upgraded my V1 arms ball cups as well as the injection molded carriages. In addition I grabbed the most recent firmware off the master path on Github. The problem I am having is that when I perform the tower alignment process the end effector center will only get to within ~=70mm of the edged of the bed. I updated both my Diagonal Rod Length (290.8mm) and Horizontal Rod Radius (140mm). Finally I am still using Repitier host, but I have always used it for calibration.
Any help would be greatly appreciated.
-Christian79