Using Cura with SeeMeCNC Orion

User-Generated tips and tricks for the Rostock Max, Orion, H1.1, or H1 Printers
Post Reply
apuglisi
Noob
Posts: 3
Joined: Tue Jan 05, 2016 10:02 am

Using Cura with SeeMeCNC Orion

Post by apuglisi »

Hi all,

I hope that this is in the right section.

I have a SeeMeCNC Orion and two Ultimakers. I am wondering if anyone has created a separate profile for their Orion using Cura? I'd like to consolidate my operation to one slicing program, if possible. Has anyone used Cura with their Orion, and are you willing to share with me the specs?

Thanks,

Andrea
apuglisi
Noob
Posts: 3
Joined: Tue Jan 05, 2016 10:02 am

Re: Using Cura with SeeMeCNC Orion

Post by apuglisi »

Oh, woah...

I think that I resolved my own problem: https://seemecnc.dozuki.com/Guide/Setti ... 87?lang=en

I'll set it up, and once I reassemble my printer, I'll give it a go.
Post Reply

Return to “General Tips 'N Tricks”