Thermistor Question

User-Generated tips and tricks for the Rostock Max, Orion, H1.1, or H1 Printers
Post Reply
nrbelk
Printmaster!
Posts: 61
Joined: Wed Jun 17, 2015 1:58 pm

Thermistor Question

Post by nrbelk »

I put this here because it could become a tip I guess haha.

My original thermister snapped in half while I was trying to solder it to the heated bed. So I got a replacement, but it comes with a cable pre-attached.

https://www.amazon.com/gp/product/B01HD ... UTF8&psc=1

With those, is there any reason to disconnect them and solder them to the heated bed? Or can I just kapton tape it down, extend the cable, and go from there, without soldering it directly to the heated bed?

nrbelk
Printmaster!
Posts: 61
Joined: Wed Jun 17, 2015 1:58 pm

Re: Thermistor Question

Post by nrbelk »

I just bought some online.

User avatar
joe
Printmaster!
Posts: 275
Joined: Tue Jun 28, 2016 10:05 pm

Re: Thermistor Question

Post by joe »

Kapton tape works. Most heat beds are taped.

Post Reply

Return to “General Tips 'N Tricks”