I tried to find something like this with the search function in the forum, but didn't succeed. So here we are:
A new cooling fan and shroud for my Rostock Max V2. I'm very satisfied with the performance - as cooling is much better than the stock fan. Hence my prints with PLA come out great, especially then ones with tiny structures:
http://www.thingiverse.com/thing:1656107
Let me know what you think.
The only caveat is that the Stock hot end gets cooled down when running at 100% fan speed. 60% is a good value for me, where 100% with the stock fan wasn't enough. I think I will replace the stock hot end to a E3D soon.
*John*
New layer cooling fan & shroud for Rostock Max V2
-
- Printmaster!
- Posts: 87
- Joined: Tue Feb 23, 2016 6:25 pm
- Location: Switzerland
- DeltaCon
- Printmaster!
- Posts: 616
- Joined: Sat Nov 14, 2015 5:01 am
- Location: Wessem, The Netherlands
- Contact:
Re: New layer cooling fan & shroud for Rostock Max V2
Nice, especially since these blower fans are a lot cheaper than the original ones...
I am DeltaCon, I have a delta, my name is Con, I am definitely PRO delta!
Rostock V2 / E3D Volcano / FSR kit / Duet 0.6
PS.: Sorry for the avatar, that's my other hobby!
Rostock V2 / E3D Volcano / FSR kit / Duet 0.6
PS.: Sorry for the avatar, that's my other hobby!
Re: New layer cooling fan & shroud for Rostock Max V2
I had two of these fans for a while now, but hadn't gotten to making a shroud for them. Was just about to, and saw this. Testing them out now!